Mummu
Ubnt Nanostation 5 loco Notes
Device data sheet: http://www.ubnt.com/downloads/loco5_datasheet.pdf
After reading http://wiki.openwrt.org/about/history I'm going to try and get this installed and running: http://downloads.openwrt.org/backfire/10.03.1-rc4/atheros/ ( which file(s) do I choose? )
openwrt install instructions: http://wiki.openwrt.org/doc/howto/installing
nanostation specific install instructions: http://wiki.openwrt.org/toh/ubiquiti/nanostation
The file I want from above is: openwrt-atheros-ubnt5-squashfs.bin
one of the reqs for instaling openwrt is a copy of the nanostation firmware. get that from here http://www.ubnt.com/support/downloads
Had AirOS 3.3.2 installed. Latest is 3.6.1.
Wow that was easy. (compared to the wrt54g v6 dd-wrt flash processes.)
- System: Atheros AR2313
- Processor: MIPS 4Kc V0.10
- Memory: 12.83 MB (33% cached, 8% buffered, 9% free)
- OpenWrt Firmware
- Backfire (r24038)
- Load: 0.00 0.00 0.00
- Hostname: OpenWrt
Setup notes
- created a wifi interface.
- created a firewall zone
- setup accpet accpet accept for lan /and wifi nets in firewall
- allowed forwarding between those nets
- put my own dns server in the /etc/resolv.conf
- put options in dnsmaq.conf dns and router
- installed syslog-ng and sent log message away
- added static route on cydonia and router to 192.168.20.0/24 ( 192.168.1.20 (mummu) )
- bssid: 02:b4:55:00:ca:fe
syslog-ng config
options {
chain_hostnames(off);
sync(0);
# The default action of syslog-ng 1.6.0 is to log a STATS line
# to the file every 10 minutes. That's pretty ugly after a while.
# Change it to every 12 hours so you get a nice daily update of
# how many messages syslog-ng missed (0).
stats(43200);
};
source src { unix-stream("/dev/log"); internal(); };
source kernel { file("/proc/kmsg" ); };
# destination messages { file("/var/log/messages"); };
destination messages { file("/tmp/messages"); };
destination d_tcp { tcp("192.168.1.64" port(514)); };
# log { source(src); destination(messages); };
log {
source(src);
source(kernel);
destination(d_tcp);
destination(messages);
};
Antenna
